CLASSIC SPORTS CAR RESTORATION AND TUNING
LECTURES, TALKS AND ANALYSIS
HOME |ABOUT | NEWS | CONTACT
 


   Home
   News

  MORGAN   
   British Sports Car
  
Strip down
   Restoration
   Modifications
  
Exhaust manifold

   Exhaust system
  
Fuel injection

   ECU TEC-3
   ECU TEC-GT
   Cam synchronization
   Turbo
  
Turbo manifold MK1
  
Turbo manifold MK2
  
Engine results
   Engine theory
  
Dyno v. Road HP_NM
   Water injection

   Air cooling
   Wind screens

   BGH Gearbox
   Anti-Tramp
   Rear Wheels
   Pictures and videos

   MyWintek services


  AVIATION
  
Flying

  
Links

 

 Strip down the Morgan

In 1995 I bought the Morgan 4/4 1965. It was thirty years old and had 110.000 km on the speedometer. The engine, was a 1600cc Ford Kent, a very reliable, small engine used in many kit cars and the Ford Cortina GT Mk2. 
 

Due to the second owner that was living near by, and the Morgan factory, I could trace most of its history.

It was used as an every day car for the first six years and already in 1971 it was worn-down so much, due to very bad rust preserving from the factory, it was necessary with a frame-off restoration. At that time the chassis and wings were electroplated. I was the fifth owner and at that time, 24 years later, it had again become rusty at certain places.
 

In spite of this, I drove it for four years, on holidays, all over Europe with great pleasure. It was 100% reliable.

One day I looked into the engine room and wanted to clean it up.

 

The engine and clutch also needed an overhaul. Taking the engine out it looked even more miserable.

 

A few day later and far to few photos later, it was totally stripped down.
 

 

 

 

A small kid with his mother passing by said: “Look he is building a boat”

Chassis 'boat'

 

 

If you will restore a car: Take lots of detailed photos.

 

It becomes much easier and takes a lot shorter time to build it up again.

 
Old steering
  TOP | HOME | CONTACT
                                                                  info@mywintek.com                 Last update 3rd October 2011                               
© Wintek